Vrrp Commands - Avaya P333R-LB Installation And Configuration Manual

Chapter 13 Layer 3 Redundancy
master of all the virtual routers, using the priority command if necessary.
For SLB, a modification to VRRP is necessary. In this case, you need to backup the
VIP (in addition to a routing interface of the router). An interface on the VIP's
subnet still has to be configured. The VIP will be configured as the Associated IP of
the VRRP.
Note: When two P333R-LBs are connected in a VRRP pair with Full NAT configured
on both, you need to configure different PIP address ranges for each P333R-LB.

VRRP Commands

The following table displays the VRRP Commands:
Figure 13.1 VRRP Commands
In order to...
Display VRRP information
Display full VRRP-related
information
Enable/disable VRRP routing
globally
Create/delete a virtual router on the
interface
Assign/remove an IP address to the
virtual router on the interface
Set the virtual router advertisement
timer value (in seconds) for the
virtual router ID
Set the virtual router priority value
used when selecting a master router
Set the virtual router simple
password authentication for the
virtual router ID
Configure the router to preempt a
lower priority master for the virtual
router ID
116
Use the following command...
show ip vrrp
show ip vrrp detail
router vrrp
ip vrrp
ip vrrp address
ip vrrp timer
ip vrrp priority
ip vrrp auth-key
ip vrrp preempt
Avaya P333R-LB User's Guide