Activating The New Scope - Avaya 4600 Series Administrator's Manual

8. Change the Data Type to String.
9. In the Code field, enter 176, then click the OK button twice.
The Predefined Options and Values dialog box closes, leaving the DHCP dialog box
enabled.
10. Expand the newly created scope to reveal its Scope Options.
11. Click Scope Options and select Action
12. In the General tab page, under the Available Options, check the Option 176 checkbox.
13. In the Data Entry box, enter the DHCP IP telephone option string as described in
Generic Setup
Note:
You can enter the text string directly on the right side of the Data Entry box under
Note:
the ASCII label.
14. From the list in Available Options, check option 003 Router.
15. Enter the gateway (router) IP Address from the IP Address field of
Network Information Before Installation - Per DHCP
16. Click the Add button.
17. Click the OK button.

Activating the New Scope

Use the following procedure to activate the new scope.
1. In the DHCP console tree, click the IP Telephone Scope you just created.
2. From the Action menu, select Activate.
The small red down arrow over the scope icon disappears, indicating that the scope was
activated.
on page 50.
Configure Options from the menu.
-->
Server.
DHCP
DHCP
Table 2: Required
Issue 2.2 April 2005 61