Kyocera KM-4230 Service Manual page 409

2A3/4
( 7 ) Adjusting the margins for scanning the original from the DF
Perform the following adjustment if margins are not correct.
U402 U403
(P.3-3-20) (P.3-3-40)
Caution: Before making the following adjustment, ensure that the above adjustments
have been made in maintenance mode.
<Procedure>
Enter maintenance mode.
Enter "404" using the numeric keys.
Press the print key.
Select the item to be adjusted
on the touch panel.
Press the interrupt key.
Place an original on the
DF and make a test copy
Are the margins correct?
B
3-3-100
U404
Start
No
Yes
A
Touch panel display
DF A MARGIN: DF left margin
DF B MARGIN: DF leading edge margin
DF C MARGIN: DF right margin
DF D MARGIN: DF trailing edge margin
Press the print key.
The new setting is stored.
Change the setting.
• Increasing the value using the
Up key makes the margin
wider.
• Decreasing the value using the
Down key makes the margin
narrower.
Setting range (default)
DF left margin: 0 - +20 (2)
DF leading edge margin: 6 - +20 (6)
DF right margin: 0 - +20 (2)
DF trailing edge margin: 0 - +20 (6)
Changing the value by 1 moves
the margin by 0.5 mm for all.