Kyocera KM-4230 Service Manual page 400

Hide thumbs Also See for KM-4230:

Table of Contents

( 2 ) Detaching and refitting the DF separation pulley

Clean or replace the DF separation pulley as follows.

1. Open the DF reversing cover.

2. Remove the two screws holding the upper original feed section cover and then the

3. Remove the two screws holding the DF rear cover.

4. Remove the screw holding the fulcrum pin and then the pin.

5. Detach the 6-pin connector and remove the original table.

Figure 3-3-108

6-pin connectors

Original table

Chapters

Table of Contents