Revo RH16NVR1 Operation Manual page 56

Part 3 - Configuration
• Set: Choose a preset number and then enter a
name. This saves the current preset under the
specified preset number and name.
• Go to: Select a preset from the list and then
click Go to to move the camera to the selected
preset position.
• Edit: Used to change the selected preset's
name.
• Remove: Used to remove the selected preset.
2 Scan
Used to set up a profile for moving the camera
between two points. At least two presets must be
available in order to use the scan feature.
• Set: Used to set up a scan profile.
- Name: Enter a name for the scan profile.
- Start/Stop: Specify which presets to use as
start and stop points.
- Dwell Time (sec.): Specify how long the
camera will dwell at start and stop positions.
- Speed/Direction: Specify scanning speed
and direction.
• Test: Select a scan profile and then click Test to
test it.
• Edit: Used to edit the selected scan profile.
• Remove: Used to remove the selected scan
profile.
56
3 Pattern
Used to set up a pattern profile for the camera to
follow along.
• Start recording: Select a pattern number,
enter a name for the pattern, and then click OK
to save the pattern. Move the camera using
directional, zoom, and focus buttons and then
click Stop recording to save the pattern profile.
You can record up to two minutes of movement.
- Directional Buttons (
Used to tilt and pan the camera.
- Zoom ( ): Zoom in and out.
- Focus (
): Adjust camera focus to far
or near.
- Speed: Specify the camera's panning and
tilting speed.
• Test: Select a pattern profile and then click Test
to test it.
• Edit: Used to edit the selected pattern profile.
• Remove: Used to remove the selected pattern
profile.
4 Tour
Used to set up a tour profile of multiple functions in
a designated sequence.
):