Revo RH16NVR1 Operation Manual page 17

1 ID Button
Used to assign remote control ID values.
No additional remote control assignment is
necessary if the system's ID is 0. If the system's
ID is a number between 1 and 9, however, you
will need to press the ID button and then press
the system ID number (1 through 9) on the remote
control. The (remote control) icon will appear
on the bottom left corner of the NVR screen (status
indication area) to indicate successful system-to-
remote control pairing. If using multiple systems,
it's possible to control all the units with a single
remote control as long as all the system IDs are 0.
For more information on system IDs, refer to the
System Setup on page 35.
2 PANIC Button
Pressing this button commences recording
irrespective of the current schedule.
Press the button again to deactivate Panic
Recording mode.
3 Camera Buttons
Pressing the Camera button while in Live or
Playback mode displays images from the selected
camera in full screen.
4 STATUS Button
Displays event and recording device statuses.
5 LAYOUT Button
2x2 > 3x3 > 4x4
6 PTZ Control Buttons
Used in PTZ mode to zoom in/out on the screen
and to shift focus between a nearby point and a far
away point.
7 REGISTER MODE Button
Used in Live mode to access Camera Registration
mode.
8 THUMBNAIL Button
Used in Playback mode to access Thumbnail
Search mode. Thumbnail Search mode displays
thumbnails of video recordings and allows you
to search recordings based on date and time
parameters. (Will be supported.)
9 CALENDAR Button
Used in Playback mode to display the Calendar
Search screen.
0 KEYLOCK Button
Locks out all remote control keys. To unlock, press
the button again.
! SETUP Button
Displays NVR and IP Camera Setup window and
allows you to search the log.
@ FREEZE Button
Used to pause Live screen.
# LOG Button
Displays system log window and allows you to
search the log.
$ Enter Button
Used to make menu option selections and register
data entries. In addition, pressing the Enter button
while in Live or Playback mode initiates Cameo
mode.
% Arrow Buttons
Used to navigate through menus and interact with
GUIs. In a Setup menu, use the Up/Down Arrow
buttons to increase or decrease numerical values.
In Live or Playback mode, use the Left/Right
Arrow buttons to view the previous or next screen.
^ ALARM Button
Pressing this button while the alarm has been
activated resets all NVR outputs, including the
built-in buzzer. Displays the event log on the screen
when the alarm is off in Live mode.
& SEQUENCE Button
Pressing the SEQUENCE button while in Live
mode initiates Live Sequential mode (displays
channels in sequence).
* ZOOM Button
Used to zoom in on a specific part of the screen.
Once zoomed in, use the arrow buttons to pan
around.
Part 1 – Introduction
17