Rear Panel Connections - Revo RH16NVR1 Operation Manual

Rear Panel Connections

Monitor Connection
Connect to the VGA OUT or HDMI port.
Audio Connection
Connect the speakers with a built-in amplifier to the
AUDIO OUT port. Use the AUDIO OUT port to listen
to audio from network cameras.
• This NVR does not feature a built-in audio amplifier
unit and therefore requires the user to purchase a
speaker system with a built-in amplifier separately.
• Check your local laws and regulations on making
audio recordings.
• AUDIO IN(Audio input) port is not supported.
Video Connection
• Video In/PoE Port
Connect network cameras to the NVR using RJ-45
cable (Cat5, Cat5e, or Cat6). In addition to cameras,
you can connect external hubs to form a network. The
NVR recognizes network cameras automatically.
• For the external hub, we recommend using an
Ext. port to enable functions such as camera
alignment.
• Green LED on the right will turn on when PoE
comes on line. Orange LED on the left will then
flash once a link has been established.
• Video In/Ext. Port
This port does not support PoE. It's possible to
establish a network with network cameras and
external hubs using Cat5, Cat5e, and Cat6 cables.
• This port only supports in 8/16 channel.
• Green LED on the right will turn on if connected to
a 1000 BASE-T network. Orange LED on the left
will then flash once a link has been established.
Network Connection
This NVR is capable of connecting to networks via
an ethernet connector. Connect an RJ-45 cable
(Cat5, Cat5e, or Cat6) to the NVR's network port. It's
possible to operate and upgrade the NVR remotely
over a network. Fore more information on ethernet
connection setup, refer to Network Setup on page
49.
Green LED on the right will begin to flash if
connected a 1000 BASE-T network. Orange LED
on the left will then flash once a link has been
established.
RS232 Connection
Connect an external device such as a POS unit to this
port.
Part 1 – Introduction
13