Network Setup; General; Ip Address - Revo RH16NVR1 Operation Manual

Network Setup

Refer to the Menu Use on page 34 for basic
information on using the Setup menus.

General

• Remote Audio Channel: Transmits the selected
channel's audio to the remote program. Select
Select from REVO Remote to stream audio of the
channel selected on the remote program.
Audio skipping and sync issues can occur under
poor network conditions.
• Enable SSL for Transferring Data: Applies
SSL (Secure Sockets Layer) protection on remote
viewing and recording data transmissions.
• If using the SSL feature, it will not be possible to
connect to the NVR from a remote program or a
network keyboard that does not support SSL.
• Changing the SSL setting temporarily severs all
remote connections to the NVR in order to apply
the change.
• This product contains content developed by
OpenSSL Project for use in Open SSL Toolkit
(http://www.openssl.org/).
• REVO Remote: If you wish to use REVO Remote,
select REVO Remote - Use REVO Remote
Service. Select REVO Remote - REVO Remote
Port and choose a port number between 12001
and 14000. For more information on REVO Remote,
refer to the REVO Remote on page 69.

IP Address

Designate the IP address type as Manual or DHCP.
Manual
• Set Type to Manual.
Manual lets you configure related settings manually.
Configure IP Address, Gateway, and Subnet
Mask settings manually using the remote control's
arrow buttons.
• DNS Server: Enter the DNS server's IP address.
• Remote Port: The port used by the remote
program to connect to the NVR. Choose a value
between 8000 and 12000.
• Remote Callback: Set the port number using for
remote callback.
• If using a firewall, select Change Port to change
the port number to one that is permitted by the
firewall.
• Changing the port temporarily severs the NVR's
remote connection.
Remote point IP and port settings on the remote
program must also be changed in order for it to
connect to the NVR.
• To use the UPnP (Universal Plug and Play) feature,
select Use UPnP. If using an IP router (or NAT),
UPnP service allows the device to automatically
forward the port to the NVR.
Part 3 - Configuration
49