Revo RH16NVR1 Operation Manual page 28

Part 2 - Getting Started
0 Status
Event
This screen displays an overview of all events.
When an event occurs, the corresponding channel
flashes for 5 seconds.
Event Types
Alarm-In
Motion
Audio Detection
Tampering
• Panic Record: Displays event status based on
current Panic Record status.
• Check Recording: Displays event status based on
System Monitoring settings. For more information,
refer to the Monitoring on page 39.
• Disk Almost Full/Disk Full: If the storage device
is not in Recycle status, event status is displayed
when the amount of disk space specified under
System Monitoring is reached and when the disk
becomes 100% full. For more information, refer to
the Monitoring on page 39.
• Fan Error: Event is indicated when the cooling fan
cannot reach a certain RPM or fails for longer than
50 seconds.
• Disk Config Change: It will be highlighted when
the NVR reboots after the hard disk drive has been
replaced.
28
Storage
Indicates each disk's status.
• Disk Bad
Check Alarm-In
Video Loss
Trip Zone
Text-In
• Temperature
• S.M.A.R.T.
Not A disk that has never been used
Formatted before.
• Disk performing normally.
• If the HDD is partially damaged,
Good
indicates the bad sector
percentage.
• If the HDD's bad sector ratio is
higher than as designated by the
Error
user.
• Generates a system event.
Unable to detect the disk's
N/A
temperature.
Operating within normal
Good
temperature range.
• Disk temperature higher than as
designated by the user.
Bad
• Generates a system event.
A disk that does not support
N/A
S.M.A.R.T.
A disk with normal S.M.A.R.T.
Good
status.
A disk with abnormal S.M.A.R.T.
Bad status. Possibility of damage within
24 hours.
• Configure Disk Bad and Disk Temperature settings
under Setup > System > Monitoring.
• Check each disk's data storage time information
under Recording Data.