Regency LRI6E-NG Owners & Installation Manual page 25

HRI6E / HRI4E
5. Place Log 3, rest on Log 2, match pin locator on Log 2 with landing
pin on Log 1. Angle the longest point on Log 3 is approximately 1/4'
from the outside edge of the burner tray.
1
Line up pin locator and pin, Logs 1,3
6. Place Log 4, match pin locator on Log 4 with landing pin on Log
1. Angle the longest point on Log 4 is approximately 1/4' from the
outside edge of the burner tray.
4
Line up pin locator and pin, Logs 1,4
7. Place Log 5 across Log 4,match pin locator on Log 5 with landing
pin on Log 4.
Note: there are 2 pin locators on Log 5, lower locator is for HRI4E
units and the upper locator is for the HRI6E units.
5
Line up pin locator and pin, Logs 5,4
919-350a
3
2
1
3
2
1
HRI6E Pin Landing
HRI4E Pin Landing
4
8. Place Log 6 - rest on Log 3 as shown below.
9. Place Log 7 on the glass as shown below.
10. Place embers and Lava rocks on the glass as shown below.
Note: Properly positioned, Logs 3 & 4 should measure 1/4" from their
longest point to the outside edge of the burner tray.
4
1/4"
Place Lava Rock and Embers on Glass
11. Reinstall Glass Door.
12. Adjust aeration setting to fully open (manual for detailed instruc-
tions)
Note: Logs to be installed in NG units only.
2
installation
6
3
Position Log 6
7
Position Log 7
3
LRI6E / HRI6E Direct Vent Gas Insert
|
25
1/4"
| 25
07/30/14