Ricoh aficio 480w Operating Instructions Manual page 78

Troubleshooting
Message
Memory is full.
3
Rotate Sort is not
available with this
image size.
Select another paper
or cancel Rotate
Sort mode.
Maximum number of
sets is NN
Original was misfed
at following point.
Open the part as
shown, then remove
it.
Paper was misfed at
following point.
Open the part as
shown and remove it.
68
Problem/Causes
The machine's memory is full
due to scanning originals or
performing a function. The
number of originals that can
be stored in memory depends
on the size of originals and
function settings.
The scanned original is too big
to rotate.
An unsuitable paper size for
rotate sort has been set.
The number of copies exceeds
maximum.
The original has jammed
(original misfeed).
The copy paper has jammed.
Solutions
• When Sort is selected,
press [Exit] to copy
scanned originals, and
then copy remaining origi-
nals.
• When the Job Preset func-
tion is selected, check the
number of preset jobs, and
then try scanning the orig-
inals again.
You cannot use rotate sort
with A0 (E), A1(D) originals.
Set paper of the following pa-
per width:
❖ ❖ ❖ ❖ Metric version:
• 594 mm and 420 mm
(A2)
• 420 mm and 297 mm
(A3)
• 297 mm and 210 mm
(A4)
❖ ❖ ❖ ❖ Inch version (Engineer-
ing)
1
• 8 / " and 11" (A)
2
• 11" and 17" (B)
• 17" and 22" (C)
❖ ❖ ❖ ❖ Inch version (Architec-
ture)
• 9" and 12" (A)
• 12" and 18" (B)
• 18" and 24" (C)
Change the maximum copy
quantity you can make at a
time. See p.86 "Max. Copy
Quantity".
Follow the on-screen instruc-
tions to remove the jammed
original. See "xClearing Mis-
feeds", General Settings Guide.
Follow the on-screen instruc-
tions to remove the jammed
paper. See "xClearing Mis-
feeds", General Settings Guide.