Hardware Identification Chart - Stamina UX2 Air Bike Owner's Manual

HARDWARE IDENTIFICATION CHART

This chart is provided to help identify the hardware used in the assembly process. Place the washers or
the ends of the bolts or screws on the circles to check for the correct diameter. Use the small scale to
check the length of the bolts and screws.
3/16" 1/4"
0 1/2 1
0 10 20
6
NOTICE: The length of all bolts and screws, except those with flat
heads, is measured from below the head to the end of the bolt
or screw. Flat head bolts and screws are measured from the
top of the head to the end of the bolt or screw.
After unpacking the unit, open the hardware bag and make sure that you have all the following items.
Some hardware may be already attached to the part.
5/16" 3/8"
1/2 2 1/2
30 40 50 60
8 10
Part No. and Description
51
57
58
59
35
62
64
70
71
33
38
39
67
1/2"
3 1/2 4
70 80 90 100 110 120 130 140 150
MILLIMETERS
12
Carriage Bolt (M8 x 1.25 x 38mm)
Screw, Round Head (M5 x 0.8 x 12mm)
Screw, Flat Head (M5 x 0.8 x 15mm)
Bolt, Round Head (M6 x 1 x 12mm)
Thin Nut (1/2" - 20)
Nylock Nut (M8 x 1.25)
Acorn Nut (M8 x 1.25)
Arc Washer (M6)
Arc Washer (M8)
Pedal Washer (1/2")
Bushing Washer (ø16.3 x ø25 x 0.5t)
Large Washer (M8)
Washer (M8 x ø16mm x 1.5mm)
6
INCHES
1/2 5 1/2
length
length
6
in.
mm.
Qty
2
4
1
4
2
5
2
4
2
2
2
2
3