Stamina UX2 Air Bike Owner's Manual page 10

ASSEMBLY INSTRUCTIONS
IMPORTANT
STUDY THE FOLLOWING ILLUSTRATION AND READ ALL OF STEP 8 "a" through
"f" BEFORE ATTACHING PEDALS AND CONNECTING LINKAGES.
STEP 8
NOTE: The RIGHT PEDAL(32) has R marked on the bottom side of the pedal. The LEFT PEDAL(31) has
L marked on the bottom side of the pedal. Both PEDALS(31, 32) have RIGHTHAND THREADS.
Tighten both PEDALS(31, 32) by turning clockwise.
a. Slide the two PEDAL WASHERS(1/2")(33) onto both PEDAL SHAFTS of PEDALS(31, 32).
b. Insert PEDAL SHAFTS of PEDALS(31, 32) through the LINKAGES(9).
c. Slide SPACERS(34) onto PEDAL SHAFTS.
WARNING: SPACERS(34) must be between LINKAGES(9) and CRANK(10) so that there will be enough
clearance between LINKAGES(9) and CRANK(10).
d. Thread PEDAL SHAFTS of PEDALS(31, 32) into CRANK(10) and securely tighten.
e. Hold PEDAL SHAFTS and thread THIN NUTS(1/2"-20)(35) onto PEDAL SHAFTS.
f. Tighten PEDAL SHAFTS and THIN NUTS(1/2"-20)(35) until THIN NUTS(1/2"-20)(35) are tight.
STEP 9
Install two AA batteries into the METER(47), the batteries are not included. See page 12 for detailed battery
installation instructions. Plug the SPEED PICKUP WIRE(23) into the connecting wire on the METER(47).
Slide the METER(47) onto the plate on the MAIN FRAME(1).
NOTE: Be careful not to damage the wires when attaching the METER(47).
10