Winding The Bobbin - ELNA eXcellence 680 Instruction Manual

w
e
q
w
e
r
e
r
e
w

Winding the Bobbin

Removing the Bobbin
Slide the hook cover release button to the right, and
q
remove the hook cover plate.
Lift out the bobbin from the bobbin holder.
r
Setting the spool of thread
Lift up the spool pin. Place the spool of thread on the
spool pin.
Attach the large spool holder, and press it firmly against
the spool of thread.
Use the small spool holder to hold narrow or small spools
of thread.
Use the spool holder (special) to hold the specific size of
the spool of threads as shown.
The sizes of the spools of thread are as follows;
The hole diameter of the spool has a range of 3/8˝ to
7/16˝ (9.5 to 10.5 mm), and the spool length has a range
of 2 3/4˝ to 3˝ (70 to 75 mm).
t
Firmly insert the spool holder (special) into the hole and
hold the spool as illustrated.
Extra spool pin
Use the extra spool pin when you need to wind a bobbin
without unthreading the machine while working on a
sewing project.
Insert the extra spool pin into the hole as shown.
q
Place a spool of thread on the extra spool pin and fix the
spool with the spool holder.
19
q Hook cover release button
w Hook cover plate
e Bobbin
NOTE:
Use the "J" plastic bobbins (marked with "J" r) or
Easy bobbin for horizontal hook. Using other bobbins,
such as pre-wound paper bobbins, may cause
stitching problems and/ or damage to the bobbin
holder.
q Large spool holder
w Small spool holder
e Spool holder (special)
r Hole diameter (3/8˝ to 7/16˝)
t Spool length (2 3/4˝ to 3˝)
q Extra spool pin
w Hole for extra spool pin
e Large spool holder
NOTE:
The extra spool pin is also used for twin needle
sewing.