Step 4, Install Support Frame And Duct Covers - Monogram ZV421 Installation Instructions Manual

Installation Instructions
STEP 4] INSTALL ACCESSORY (OR SUPPLIED) SUPPORT AND DUCT COVERS
i'
/
/
Install
Safetg Screw
on Each Side
?
Screws E
Adjust
Frame to
nstallation
Height
Install Small Pan Hea
Screws on Each Side
/
iF
Screws D
Install Stop
Screw \
Stop Screw
Storage Location
Install supplied support frame OR telescoping accessorg
frame
, Hang the supplied support frame or telescoping
accessory frame to the ceiling joists and cross
framing on the 4 hex head screws by engaging the
keyhole slots on the frame.
, Check to be sure the support frame is level, vertically
and horizontally.
, Tighten the hex head screws securely.
, Install safety screws, (Screws E)on each side of the
frame.
Adjust telescoping accessorg frame to length
, Remove the 8 frame adjustment screws. Adjust the
lower support up or down to the pre-determined
length. Reinstall and securelg tighten the 8
adjustment screws.
, Slide the top (inner) accessorg duct cover up and
over the frame. Secure the duct cover to the frame as
shown using Screws D.
, Locate and remove the safetg stop screw. Slide
bottom duct cover up and over the top duct cover.
Align bottom duct screw hole to the hole in the
frame. Hold the duct cover in place while installing
screw.
_L,/_V|lVl_: The stop screw
must be installed. Failure to do so could result in
personal injurg or damage to the duct cover. The stop
screw will prevent the lower duct from sliding down
while completing the installation.
APRUDENCE
II faut mettre en place la vis de but6e afin d'6viter des
blessures ou d'endommager I'enceinte du conduit. La
vis de but6e emp_che I'enceinte inf@ieure du conduit
de descendre pendant I'installation.
Secure house wiring
, Route house wiring through the ceiling and pull a
length to reach the hood junction box, approximatelg
6" below the support. Tape to the right side of the
support frame.
IMPORTANT: Again, check to be sure the support is
level in both directions. There is no wag to level the
hood after the hood is secured to the frame.