Table of Contents
Advertisement
Installation
Instructions
STEP 13 INSTALL SUPPLIED DUCT
COVER AND TOP COVER
iF
Screws
O
lnstall Duct
Cover Screw
n EachSide
, Install the supplied 2-piece duct cover over the
support frame (if using supplied frame). Snap ends
together.
, Secure duct covers to support frame with 2
Screws D.
, For o more finished appearance,
a top cover is
supplied and should be installed whenever the top
of the hood is visible.
TIP:Place pieces
of tape over ends
of the cover to
prevent scratch-
ing the duct
cover. Remove
tape before
installing screws.
,,Tab.<
, Engage tabs into slots on each side at the top of
the hood. The covers should lag flat in the impres-
sion on top of the hood.
Screws
C
ove
/
Install Screws
t\
Front and Back
, Install 2 Screws C to secure the cover to the hood
at the front and back.
[STEP 14] FINALIZE INSTALLATION
, Check all lamps to assure tightness in sockets.
, Turn power on at the circuit breaker.
, Refer to the Owner's Hanual for operating
and
cleaning instructions.
STEP 151 INSTALLATION
CHECKLIST
Check Blower Safetg Screw
[] Ensure that blower safetg screw is securelg tight-
ened. See page 16, Step 9. If screw is missing, order
replacement
ports bag.
Check Operating
Sound and Proper Air-Flow
[] Turn blower to each speed setting and listen for
rattles and vibration. You should notice an audible
difference
at each speed setting.
[] Check for foreign material in transition.
[] Check that blower screen is not damaged
or pushed
into the blower impeller.
[] The damper should move freely. Listen for opening
and closing while turning the unit on and off.
[] Check that the damper is not damaged, does not
vibrate and that damper
bumper pads are in place.
Order a damper
replacement
assembly if needed.
[] Check that ductwork
is 10" round. If duct type is not
rigid and less than 10" round, inform the consumer
that performance
will be reduced.
Check Lighting
Function
[] Check that power cable is plugged into the junction
box on top of the hood.
[] Turn halogen lamps to each setting. Note change in
brightness
at different settings.
[] Check that each lamp bezel is secure. Turn to the
right to tighten. Order replacement
lamp bezel and
socket assemblies if needed.
Check appearance
and installation
[] Use a spirit level to check that the hood is level.
Review installation
instructions
to determine source
of problem.
[] Top covers (if used) should lay flat in the recess on
top of the hood. Hake sure side tabs are engaged in
slots and the cover is secured with two screws.
[]
Clean the hood surfaces and all filters. See the
Owner's Hanual for cleaning instructions. They
should be free of construction
debris such as
sawdust.
Advertisement
Table of Contents
