Step 3 Connect Ductwork; Step 4 Connect Electrical; Step 5, Install Duct Covers; Step 6 Install Motor - Monogram ZV48T Installation Instructions Manual

STEP 3 CONNECT DUCTWORK

• Install ductwork, making connections in direction of
• Secure joints in ductwork with sheetmetal screws.
• Wrap all duct joints with duct tape for an airtight seal.
inside the hood and push the damper up to be sure it
moves freely.
Duct Tape
Over Seam
and Screw
Duct Tape
Over Transition

STEP 4 CONNECT ELECTRICAL

Verify that power is turned off at the source.
WARNING:
2-wire with a ground wire, a ground must be provided by
the installer. When house wiring is aluminum, be sure to
use U.L. approved anti-oxidant compound
and aluminum-to-copper connectors.
AVERTISSEMENT
terre, l'installateur doit fournir un circuit de terre. Quand
d'utiliser de la pâte antioxidation approuvée par UL et
des connecteurs pour l'aluminium-cuivre.
A
Remove B
Insert Power
Junction Box
Conduit Thru
Cover
Strain Relief
and Tighten
Ground
C
Use UL Listed
Wire Nuts
• Use wire nuts to connect incoming ground to green,
white to white and black to black.
• Push wires into junction box and replace cover. Be sure
wires are not pinched.
14
Installation Instructions
Air Flow
Screw
If house wiring is not
Si le câblage de
White
Black
Note: For easier handling, remove cardboard insert after
one duct cover is used, secure each piece together with
screws provided.
• Place the duct cover(s) on top of the hood.
• From inside the hood, secure the duct cover to the top
with the small Phillips head screws supplied with the
covers.

STEP 6 INSTALL MOTOR

Outlet
Attachment
Slot
• From the inside of the hood, slip motor into the
attachment slot on the left.
• Rotate motor upwards until it snaps into the spring clip
on the right.
• Secure the motor to the hood with the machine screw
and lock washer. (Screw is marked with red or blue
paint.)
Top
IMPORTANT: Connector
ends are designed to mate
round connectors as shown.
• Plug connector into the motor.
Spring
Clip
Attachment
Screw
Spring
Clip
49-80151-8