Table of Contents
Advertisement
Installation
instructions
ISTEP 5J
INSTALL DUCT TRANSITION
WITH DAMPER
Pads
i
/
Duct
Transition
Screws
C
Attachmen
Screws
INPORTANT: Remove shipping tape from damper
and check that damper
moves freelg.
, Place the transition
piece over the hood exhaust
and secure with 4 Screws C provided.
, Use duct tape to seal the connection.
Check to be
sure the damper moves freelg.
ISTEP 6J INSTALL HOOD
Note: THREE PEOPLE ARE REQUIRED TO COMPLETE
THIS INSTALLATION!
/
Attachment /
Keyholes_
, Back out the hanging screws on the bottom of the
support frame to a 1/4" gap.
, Lift the hood up to the support frame. Carefullg
align the hood keghole to the screws on the support
frame. Slide the hood to engage the keghole slots.
, Tighten the screws.
Screws
C
Install
I-2Safetg I
I Screws
, Install safetg screws into the top of the hood as
shown.
, Check hood level in both directions.
[STEP7J
CONNECT
DUCT
, Loosen duct collar and slide down to cover
gap between
transition
and
house duct.
Tighten collar
screws and tape
_.
_...o:
alljoints.
, Seal all
k
connections
with
duct tape.
Slide Duct
Collar Down
to Cover Gap
Note: Do not drive screws through
this duct
connection.
Doing so will prevent proper damper
operation.
16
49
80209
5
Advertisement
Table of Contents
