Password Setting - JETWAY NC97 Technical Manual

CPU Ratio
Use this item to set CPU ratio. This setting will only take effect when SpeedStep-tech
is set as Disabled.
CPU Vcore-7 Shift
Use this item to set value in CPU Vcore 7-Shift function. Optional settings are:
Normal; +50mV to 350mV.
CPU AGX Voltage Select
The optional settings are: Normal; +50mV~+350 mV.
DRAM Voltage Select
Use this item to set DRAM voltage.

3-12 Password Setting

You can set either supervisor or user password, or both of them. The differences are:
Supervisor password:
User password:
ENTER PASSWORD:
Type the password, up to eight characters in length, and press <Enter>. The
password typed now will clear any previously entered password from CMOS memory.
You will be asked to confirm the password. Type the password again and press
<Enter>. You may also press <Esc> to abort the selection and not enter a password.
To disable a password, just press <Enter> when you are prompted to enter the
password. A message will confirm that the password will be disabled. Once the
password is disabled, the system will boot and you can enter Setup freely.
PASSWORD DISABLED.
When a password has been enabled, you will be prompted to enter it every time you
try to enter Setup. This prevents an unauthorized person from changing any part of
your system configuration.
Can enter and change the options of the setup menus.
Can only enter but do not have the right to change the options
of the setup menus.
following message will appear at the center of the screen to
assist you in creating a password.
35
When you select this function, the