Password Setting; Ide Hdd Auto Detection - JETWAY 920BFR3A User Manual

•
Parallel Port Mode : Select an operating mode for the onboard parallel (printer) port.
Select Normal, Compatible, or SPP unless you are certain your hardware and software
both support one of the other available modes.
The choice: SPP, EPP, ECP, ECP+EPP.
•
ECP Mode Use DMA : Select a DMA channel for the parallel port for use during ECP
mode.
The choice: 3, 1.
•
PS/2 mouse function : If your system has a PS/2 mouse port and you install a serial
pointing device, select Disabled.
The choice: Enabled, Disabled.
• USB Controller : Select Enabled if your system contains a Universal Serial Bus (USB)
controller and you have USB peripherals.
The choice: Enabled, Disabled.
• Init Display First : This item allows you active which bus first (PCI Slot or AGP first).
The choice: PCI Slot, AGP. Default value is AGP.
• MDA Support : Enable this function allows system to support Monochrome adapter.
Default value is Disabled.
The choice: Enabled, Disabled.
• Current CPUFAN/SYSFAN Speed : These fields display the current speed of up to two
CPU fans, if your computer contains a monitoring system.
• Vcc/Vcc3/Vcc25/Vcore : These fields display the current voltage of up to four voltage
input lines, if your computer contains a monitoring system.

3-9 PASSWORD SETTING

This item lets you configure the system so that a password is required each time the system
boots or an attempt is made to enter the Setup program (Refer to Figure 3-3 for the details).
Supervisor Password allows you to change all CMOS settings but the User Password setting
doesn't have this function. The way to set up the passwords for both Supervisor and User
are as follow:
1. Choose either Supervisor Password or User Password in the Main Menu and press
<Enter>. The following message appears:
"Enter Password:"
2. The first time you run this option, enter your password up to only 8 characters and press
<Enter>. The screen does not display the entered characters. For no password just
press <Enter>.
3. After you enter the password, the following message appears prompting you to confirm
the password:
"Confirm Password:"
4. Enter exact the same password you just typed again to confirm the password and press
<Enter>.
5. Move the cursor to Save & Exit Setup to save the password.
6. If you need to delete the password you entered before, choose the Supervisor Password
and Press <Enter>. It will delete the password that you bad before.
7. Move the cursor to Save & Exit Setup to save the option you did, otherwise the old
password will still be there when you turn on your machine next time.

3-10 IDE HDD AUTO DETECTION

The "IDE HDD AUTO DETECTION" utility is a very useful tool especially when you do not
know which kind of hard disk type you are using. You can use this utility to detect the correct
disk type and install in the system automatically. Also you can set HARD DISK TYPE to
"Auto" in the STANDARD CMOS SETUP to have same result. The BIOS will Auto-detect the
hard disk size and model on display during POST.
ROM PCI/ISA BIOS (2A6INJ19)
STANDARD CMOS SETUP
AWARD SOFTWARE, INC.
28