Problem Solving Guide; Fault Messages In The Display - Miele T 8001 WP SUPERTRONIC Operating Instructions Manual

Problem solving guide

Most faults can be resolved by yourself. This will save time and money as a
call-out charge will apply to customer service visits where the problem could have
been rectified as described in these Operating instructions.
With the help of the following notes, minor faults in the performance of the
appliance, some of which may result from incorrect operation, can be put right
without a call-out being necessary. Please note:
,
Repair work to electrical appliances must only be carried out by a suitably
qualified and competent person in strict accordance with current local and
national safety regulations. Repairs and other work by unqualified persons
could be dangerous. The manufacturer cannot be held liable for unauthorised
work.

Fault messages in the display

Problem
You are asked to enter a
code.
Adjust the load
1
The programme is
cancelled and the
buzzer sounds.
Empty the container
N
Empty the container or
check the drain hose.
The programme is
cancelled and the
buzzer sounds.
Possible cause
Access via a code has
been activated.
This is not a fault.
In some programmes,
if the drum has been
overloaded or
underloaded, the
programme will be
cancelled. This can
also happen if the
items are already dry.
The condensed water
container is full or there
is a kink in the drain
hose.
Problem solving guide
Remedy
Enter the code (see
Settings menu).
Use the Warm air
programme to dry
individual items.
– Open and close the
door.
– Empty out the
condensed water
container or check the
drain hose.
To clear the display:
– Switch the dryer off
and then on again.
45