Related Manuals for Miele T 8002 VENT ED DRYER
Summary of Contents for Miele T 8002 VENT ED DRYER
- Page 1 Vented Dryer T 8002 T 8003 T 8005 en - US, CA To prevent accidents and appliance damage read these instructions before installation or use. M.-Nr. 06 879 010...
-
Page 2: Table Of Contents
1. Turn on the dryer and load the laundry ....... . -
Page 3: Important Safety Instructions
If these items have not been thoroughly cleaned there is a danger Do not allow children to play on or in that they may contribute to a the appliance. Close supervision is chemical reaction that could cause... -
Page 4: Save These Instructions
Do not modify the plug provided with the appliance: if it will not fit the outlet, have a proper outlet installed by a qualified electrician. SAVE THESE INSTRUCTIONS... -
Page 5: Control Panel
If the dryer is on, the drum interior will light when the door "Status" display is opened. If the door is left open, the light will go off after a few minutes to Shows the current cycle of the drying program. -
Page 6: Before Loading The Dryer
Fluff / 20 min / 45 min – Do not dry items that may melt or – All fabric types ignite in the dryer, such as plastics, rubber or sneakers. -
Page 7: Using The Dryer
^ Press the "Door" button to open the door. ^ Load the laundry loosely into the drum. ^ Make sure the lint filters are in place. ^ Close the door. For best results use liquid fabric softener when washing laundry. - Page 8 Permanent press and blended fabrics Reduce load size for fabrics that wrinkle requiring an ironed finish. easily. Special Programs Available drying options: Anti-crease only available in Fluff, Sturdy Woolens Delicate items which allow machine Remove items immediately at the end of drying.
-
Page 9: Select A Drying Option (If Needed)
Gentle For drying delicate fabrics at a lower temperature with an extended program time. ^ A drying option can be selected or deselected with each press of the Anti-crease button. Prevents wrinkles if laundry is not removed immediately after the end of a program. -
Page 10: Select The Dryness Level
Using the dryer 4. Select the dryness level 5. Select the buzzer (if desired) ^ Press the "Buzzer" button to have a The dryness level can be selected in the "Normal" and "Wrinkle-free" tone beep at the end of the program. -
Page 11: Start The Program
6. Start the program 7. At the end of a program The "End/Anti-crease" indicator will light at the end of a program and the buzzer will sound if it was selected. If a fault occurred, a "FAULT" indicator ^ Press the "Start/Stop" button. -
Page 12: Canceling Or Changing A Program
Canceling or changing a Adding or removing laundry program during a program ^ Press and release the "Start/Stop" ^ Turn off the dryer using the "On/Off" button to stop the drying program. button. ^ Press the "Door" button. To continue drying: ^ Select the new program by pressing ^ Open the door. -
Page 13: Child Lock
The door can be opened. To activate the child lock 1. Make sure the dryer is turned off and the door is closed. 2. Press and hold the "Anti-crease" and "DRYNESS" buttons at the same time, hold until step 5. -
Page 14: Dryer Care
A clogged filter is a fire hazard! The lint filter must be cleaned after every program. ^ Wipe the lint off the filter with your hand (do not use sharp objects). ^ Any lint remaining in the hollow part of the door can be removed through the gap at the bottom with a dust brush or vacuum. - Page 15 Dryer care Cleaning the grille filters ^ Clean the grille filters in the door opening regularly. While the filters are removed also clean the opening beneath the filters with a dust brush or vacuum. ^ Take the grille filters out by turning...
-
Page 16: Cleaning The Exterior And The Control Panel
Dryer care Cleaning the exterior and the Cleaning the drum control panel ^ The stainless steel surfaces of the drum can be cleaned using a To reduce the risk of electric non-abrasive stainless steel cleaner. shock, disconnect the dryer from the ^ Wipe clean with a soft cloth. -
Page 17: Changing The Light Bulb
^ Flip up the light bulb cover and press maintenance. it firmly until it clicks into place. ^ Open the door. Make sure the bulb cover is... -
Page 18: Frequently Asked Questions
The door is not closed. Close the door properly. How do I prevent static cling? Add fabric softener to laundry when washing or select the "Less Dry" setting on the dryer. What if the drum light does not come on? - Page 19 Frequently asked questions What if the "Filter/Vent" indicator lights after cleaning the exhaust system? Possible fault Solution The dryer is not operating efficiently Check the exhaust length and diameter because the duct hose is too long. (see "How to calculate the effective duct length").
-
Page 20: After Sales Service
After sales service Repairs MieleCare In the event of a fault which you cannot (only USA) fix yourself, please contact Miele's MieleCare, our Extended Service Technical Service Dept. Contract program; gives you the When contacting Technical Service, assurance of knowing that your... -
Page 21: Quick Guide
Quick Guide Remove this guide for easy reference Please read all instructions, especially the "Important Safety Instructions", before using the dryer. - Page 22 To prevent fabric damage, check ^ A drying option can be selected or that laundry will not be caught in the closed door. deselected with each press of the button. ^ Close the door with a firm swing - do not push it shut.
- Page 23 The "Anti-crease / End" indicator will light. ^ Press the "Door" button and remove the laundry. ^ Press the selection button until the ^ Clean the lint filter. desired indicator illuminates. ^ Press the "On/Off" button to turn off the dryer.
- Page 24 For items to be hung after drying. Less Dry For items which require ironing. Reduce load size for fabrics that wrinkle easily. Special Programs Available drying options: Anti-crease only available in Fluff, Sturdy Woolens Delicate items which allow machine Take items out immediately after the end drying.
-
Page 25: Installation Instructions
Installation Instructions To prevent accidents and appliance damage read these instructions before installation or use. -
Page 26: Important Safety Instructions
Install the clothes dryer according to the manufacturer's instructions and Do not modify the plug provided local codes. with the appliance! If it will not fit the outlet, have a proper outlet installed by Repair and maintenance work a qualified electrician. - Page 27 IMPORTANT SAFETY INSTRUCTIONS The installation of this unit in non stationary locations (e.g. ships) must be performed by a qualified installer or service agency, in strict accordance with national and local safety regulations and standards. Do not install the machine in rooms where temperatures below freezing may occur.
-
Page 28: Washer / Dryer Stack
Washer / Dryer Stack The tumble dryer can also be placed Height of vent adapter in a stacked on top of a Miele washing machine for a installation stacked installation. An appropriate Miele washer with a flat or angled stacking kit is required. The stacking kit... -
Page 29: Electrical Connection
Check with a qualified electrician or service representative or personnel if you are in doubt as to whether the appliance is properly grounded. Do not modify the plug provided with the appliance! If it will not fit the outlet, have a proper outlet installed by a qualified electrician. -
Page 30: Installation
Installation Exhaust connection: Control panel The exhaust hose/pipe can be Door installed either at the rear, left or right of the dryer. Four height adjustable feet Power cord with plug... -
Page 31: Installation Site
Transporting the dryer to the installation site Handle for easy transport (arrows) The rear excess end of the lid has a handle for transport. Power cord with plug ^ Use the front dryer feet and the rear Vent connection rear... -
Page 32: Installation Beneath A Counter
Reinstallation of the machine lid ^ When reinstalling the appliance lid, When removing the machine lid check the firm fit of the cover at the to reduce the height of the machine, rear bracket for safe transport of the a built under spacer kit* is dryer. -
Page 33: Leveling The Dryer
Determining the position of the exhaust connection The exhaust connection can be left at the rear of the dryer (factory standard) or moved to the left or right side of the dryer. Changing the position of the exhaust connection The dryer must be level to ensure safe and proper operation. -
Page 34: Installation Tips
Installation Installation tips Room ventilation The room air, which is taken in when An airflow gap of " (10 mm) must the dryer is in operation, is blown out be provided between the machine via the exhaust vent. It is important, and the floor. -
Page 35: Exhaust Connection
"plexiglass" pane) 2 Connector for the flexible metal exhaust hose Wall connection with rigid pipe ^ Install the exhaust hose/pipe, 2, with the connector, 1, to the dryer. 1 Wall pipe (Installation sheet supplied with the Miele wall pipe) 2 Connector... -
Page 36: Direct Wall Connection
– flexible foam gasket Dryer top view 1 Wall pipe 2 Flexible foam gasket 1 Wall pipe 2 Flexible foam gasket ^ Connect the flexible foam gasket, 2, to the wall pipe connector, 1. ^ Push the dryer to the wall. -
Page 37: How To Calculate The Effective Duct Length
Using the ring adapter up to an (see the "Additional duct lengths" effective duct length of 33 ft (10 m) and table). a standard duct diameter of 4" (100 mm) will provide optimal drying 2. - Page 38 The shorter and smoother the – Only use rigid or flexible metal duct inner walls are, the less friction will for exhausting. Non-metallic flexible be created.
- Page 39 Installation Additional duct lengths (4" rigid pipe only) Type of bend Radius Additional duct length Flexible metal duct – 3’ 3" (1 m) straight 5’ 11" – 45° angle 10" 4’ 11" – 90° angle 10" 8’ 2" Smooth metal duct –...
- Page 40 0.8 m 90° bend 3’ 3" 1.0 m left vent opening 22’ 5" 6.9 m Total duct length The total duct length is less than 33 feet (10 m), so a duct diameter of 4" (100 mm) with adapter is sufficient.
-
Page 41: Caring For The Environment
Ensure that a discarded dryer presents no danger to children. When being To prevent suffocation, ensure that any stored for disposal remove the door to plastic wrappings, bags, etc. are the drying compartment. disposed of safely and kept out of the reach of children. - Page 44 All rights reserved / 0309 M.-Nr. 06 879 010 / 03 For the most updated manual check the Miele web site.