Starting The Programme; To Start A Programme; Note On Time Remaining; Changing A Programme - Miele T 8001 WP SUPERTRONIC Operating Instructions Manual

To start a programme

Note on time remaining

It is possible to alter a programme after it has started:

Changing a programme

Start at/Finish at: Changing the time

^ Touch the green Start sensor.
Cottons
G
Normal - Extras (See :)
Time left: 2:03 h
– The time remaining appears in the display.
– The current stage of the programme is represented by
symbols in the display.
The following factors all affect the estimated time remaining in
programmes with drying levels: residual moisture content
after spinning; type of fabric; size of load; room temperature;
fluctuations in power supply or cancellation of the
programme.
Because of these factors, the time displayed can alter during
the course of a programme. This is a normal function and
does not indicate a fault.
In the same way, programmes may finish early. This can
happen with particularly fine fabrics, very small loads or if
items were partly dry beforehand.
You cannot change to another programme once a
programme has started (this prevents unintentional
alterations).
You will need to cancel the current programme before you
can select a new one.
^ Touch the Change sensor.
^ Select the Start at or Finish at option in the menu.
^ Change the time of day by pressing either
^ Confirm the time you have set with

3. Starting the programme

OK
10:21
Change !
+ -
or .
.
[
27