Setting Up One Touch Play (Hdmi-Cec) - ActionTec ScreenBeam Pro SBWD100B User Manual

3. Click the Apply button, and then click OK on the pop-up message box to confirm.

5.3.14. Setting up One Touch Play (HDMI-CEC)

Follow the procedure below to set up the receiver's One Touch Play (HDMI-CEC) function:
1. Go to the Features tab page by clicking the Features tab.
2. Go to the One Touch Play (HDMI-CEC) line, and set the One Touch Play (HDMI-CEC)
feature to On or Off.
There are two options: On, and Off. After this function is enabled, the receiver can wake up
the connected display device and the display device will switch to the source that the receiver
connects to.
The display device will be waked up in one of the following conditions:
a. when the receiver is powered on;
b. when a connection to the receiver is established; and
c. when a power-on receiver is connected to the display device.
Note: The display device must support HDMI-CEC, and this function is enabled.
3. Click the Apply button, and then click OK on the pop-up message box to confirm.
40