Setting Up Ir Control - ActionTec MyWirelessTV MWTV200T User Manual

Setting Up IR Control

MyWirelessTV comes with an IR Blaster and IR Receiver, which work
together to allow you to control the source device from the location you
are watching, whether it's in the next room or on the other side of the
house. For example, if your Blu-ray player is in the living room, and
you've set up MyWirelessTV to watch on an HDTV in the bedroom, the
IR Blaster/Receiver allows you to control the Blu-ray player from your
bedroom.
Note: If you are using MyWirelessTV in the same location (i.e., the source
device and the HDTV monitor are in the same room), the IR Blaster/
Receiver is not needed.
Connecting the IR Extender Cable
e IR Extender cable receives signals from the source device remote
control and sends them back to the source device.
1. Get the IR Extender cable (it has a green connector) from the
MyWirelessTV kit.
2. Plug the IR Extender's green connector into the green IR port on the
back of the Receiver.
3. Remove the protective covering of the double-stick tape and attach the
at end of the IR Receiver cable to the front corner of the HDTV
monitor's bezel or frame
Connecting the IR Blaster Cable
e IR Blaster cable receives the source device remote control signal from
the Receiver and delivers it to the source device.
1. Get the IR Blaster cable (it has a black connector) from the
MyWirelessTV kit.
2. Plug the black connector of the IR Blaster cable into the IR Transmit
port on the back of the Transmitter.
MyWirelessTV User Manual
13