4. The receiver reboots, and new settings take effect after the reboot.
Warning: DO NOT disable this feature, unless you have confirmed that your display
device supports that.
5.3.10. Setting up the VGA Compatibility Mode
Follow the procedure below to select a VGA compatibility mode:
1. Go to the Features tab page by clicking the Features tab.
2. Go to the VGA Compatibility Mode line, and select the desired option in the VGA
Compatibility Mode box. There are three options: Disable, 1080, and 720.
Disable: The video output is in consistence with the source device.
1080: The video output is set to 1080p or 1080i, depending on the display device.
720: The video output is set to 720p or 720i, depending on the display device.
Note: The VGA compatibility mode is not available when HDMI-CEC is enabled.
3. Click the Apply button, and then click OK on the pop-up message box to confirm.
5.3.11. Setting up USB Local Access
A USB port is provided on the ScreenBeam Pro wireless display receiver for multi-purpose
uses. You can set up the USB port in the local management page.
Follow the procedure below to set up the USB port:
37