Heat & Glo XLR-N-CE Owner's Manual page 48

Non-Combustible Finish Materials
0 cm to 10,16 cm Thick Inside Fit Method
The Tonic decorative front is approved for inside fi t appli-
cations. Non-combustible fi nishing materials up to 10,16
cm thick can be installed around the front (left, right, top,
and bottom).
For the Tonic decorative front inside fi t applications, the
decorative front must be installed tight to the fi nishing
fl anges and must not overlap any fi nish material.
Ensure that no non-combustible fi nish materials are in-
stalled within 1,9 cm of the fi replace opening. The 1,9
cm spacing is required to provide clearance for removing
and installing the Tonic decorative front. See Figure 13.9.
FACTORY-INSTALLED
NON-COMBUSTIBLE
BOARD
DRYWALL OR
EQUIVALENT
(1,3 cm)
Figure 13.8 Inside Fit Method (Tonic Decorative Front Only)
48
0-10 cm
1,9 cm
52 cm APPLIANCE
OPENING (HEIGHT)
4,6 cm
0-10 cm
Heat & Glo • XLR-N-CE, XLR-PB-CE • 2198-900 Rev. N • 3/14
Non-Combustible Finish Material 0-10 cm Thick
1,9 cm
Figure 13.9 Noncombustible Surface Finishing Material 0 - 10
cm Thick-Inside Fit Method (Tonic Decorative Front
Only)
1,9 cm
4,6 cm
Bottom Joint