Table of Contents
Advertisement
6 6
Termination Locations
A. Vent Termination Minimum Clearances
Fire Risk.
Maintain vent clearance to combustibles as
specifi ed.
• DO NOT pack air space with insulation or other
materials.
Failure to keep insulation or other materials away
from vent pipe may cause overheating and fi re.
TERMINATION
CAP
Angle
0°-26.6°
.......................................................... 30*
26.6°-30.3° .......................................................... 38*
30.3°-33.7° .......................................................... 46*
33.7°-36.9° .......................................................... 61*
36.9°-39.8° .......................................................... 76*
39.8°-42.5° .......................................................... 99
42.5°-45.0° ........................................................ 1 22
45.0°-49.4° ........................................................ 1 52
49.4°-53.1° ........................................................ 1 83
53.1°-56.3° ........................................................ 2 13
56.3°-59.0° ........................................................ 2 29
59.0°-60.3° ........................................................ 2 44
*.91 M minimum in snow regions
Figure 6.1 Minimum Height From Roof To Lowest Discharge
Opening
WARNING
HORIZONTAL
OVERHANG
51 cm
VERTICAL
WALL
LOWEST
DISCHARGE
OPENING
X
30,5 cm
ROOF PITCH
IS X/ 30,5 cm
H (MIN.) - MINIMUM HEIGHT FROM ROOF
TO LOWEST DISCHARGE OPENING
H (Min.) cm
Heat & Glo • XLR-N-CE, XLR-PB-CE • 2198-900 Rev. N • 3/14
A
15,2 cm (minimum) up to 50,8 cm
50,8 cm and over
Gas, Wood or Fuel Oil
Termination Cap
B
Gas
Termination
Cap **
*
If using decorative cap cover(s), this distance may need to be
increased. Refer to the installation instructions supplied with the
decorative cap cover.
**
In a staggered installation with both gas and wood or fuel oil
terminations, the wood or fuel oil termination cap must be
higher than the gas termination cap.
Figure 6.2 Staggered Termination Caps
B
45,7 cm minimum
0 cm minimum
A*
21
Advertisement
Table of Contents
