Table of Contents
Advertisement
TS600CW_B02.book Page 35 Tuesday, January 24, 2006 10:57 AM
If the Direct Dial button selected is
occupied, the display on the right will
be shown.
To overwrite, press [OK] (Yes key).
To select other empty Direct Dial
memory, press [
empty Direct Dial button ([M1], [M2] or
[M3]).
• A long beep sounds.
• To continue storing other items, repeat from step 2.
• To exit the programming mode, press [EXIT] or wait for 60 seconds.
• To erase other stored items from the Direct Dial memory, see below.
• When using the Call Restriction feature (p. 43), you cannot store a phone number
in the Direct Dial memory ([M1], [M2] or [M3]).
• You can exit the programming mode any time by pressing [EXIT].
• If a pause is required for dialing, press [PAUSE] where needed. If required, you
can also store [FLASH] in a phone number. Pressing [PAUSE] or [FLASH]
counts as one digit (p. 37, 41).
To erase a stored number
1
Press the required Direct Dial button
([M1], [M2] or [M3]).
2
Press [ERASE].
• To stop erasing, press [
3
Press [OK] (Yes key).
• A long beep sounds.
• To exit the programming mode, press [EXIT] or wait for 60 seconds.
] (No key), then press an
3
3
] (No key).
M1 is occupied
Overwrite ?
[
3
]=No
[OK]=Yes
Erase ?
[
3
]=No
[OK]=Yes
Erased
Memory Empty
35
Advertisement
Table of Contents
