Figure E-6. Gdl 90 Data Link (Includes Traffic - Garmin GMX 200 Installation Manual

GMX 200 MFD
3
PORT 4 CONFIG HI
NOTES: NOTES:
1. ALL WIRES 24 AWG OR LARGER UNLESS OTHERWISE SPECIFIED.
2. AT GMX 200, CONNECT SHIELD GROUNDS TO THE CONNECTOR BACKSHELL--THE SHIELD LEADS
3. JUMPER MUST BE INSTALLED AS SHOWN TO CONFIGURE PORT 4 FOR RS422 OPERATION.
4. GMX 200 MUST BE CONFIGURED FOR UAT TRAFFIC/DATA LINK SOURCE ON PORT 4.
Page E-8
Revision F
P2001
+ +
8 8
RS422 TX4
- -
10 10
4
s
+ + 11
RS422 RX4
- - 26
s
29
RS232 IN 4
3
9
MUST BE LESS THAN 3.0 ". CONNECT OTHER SHIELD GROUNDS TO AIRCRAFT CHASSIS WITH AS
SHORT A CONDUCTOR AS PRACTICAL.
IF PORT 4 IS USED AS AN RS422 PORT, RS232 PORT 4 CANNOT BE USED.
REFER TO MISC SETUP OPTIONS FOR CONFIGURING UAT FUNCTIONS.

Figure E-6. GDL 90 Data Link (Includes Traffic)

UAT DATA
GARMIN
LINK RECEIVER
GDL 90
P2
10 + +
RS422 RxD3
28 - -
+ +
11
RS422 TxD3
- -
29
GMX 200 Installation Manual
190-00607-04