5.6
V iewing GWX 68 Software Part Numbers & Versions
3 3 B
Starting with software V2.10, to view the GWX 68 software part numbers and versions:
1. Power on the GMX 200 in the install mode.
2. Press the FN key until RADAR is displayed.
3. Press the STBY/ON key.
4. Press the TEST key.
5. Press the ENT/Menu key.
6. Press the CALB key.
7. Press the VER key to view the GWX 68 software part numbers and versions.
5.7
G MX 200 Error Codes
3 4 B
In the MSG function, the text "SYSTEM" in the source column with "Reset Code was" followed by a
four-digit code in the Message column may appear after a unit reset when the software encounters an
unexpected set of conditions. This code may provide information about the cause of the reset and should
be reported to Garmin Technical Support as soon as practical for further analysis. Garmin Technical
Support may also request a copy of other files located on the front loading datacard to assist with the
analysis. If an error condition does not return after the unit resets, the cause is likely temporary and the
Page 5-30
Revision F
unit will continue to operate properly.
GMX 200 Installation Manual
190-00607-04