Figure E-7. Traffic - Garmin GMX 200 Installation Manual

GMX 200 I/O MFD
RS-232 OUT 3
7
RS-232 IN 3
SERIAL GND 3
NOTES
1.
2.
3.
4
5
6
7
8
9
GMX 200 Installation Manual
190-00607-04
TYPICAL CONNECTION TO ARINC 429 TRAFFIC SOURCE
GMX 200 I/O MFD
P2002
A 59
ARINC 429 IN
B 58
DISCRETE OUT 2 6
DISCRETE OUT 3 7
CONNECTIONS TO RYAN TCAD
RYAN
9900B
9900BX
P1
P2001
6 22
7 20
25 21
S
ALL WIRES 24 AWG OR LARGER UNLESS OTHERWISE SPECIFIED.
AT GMX 200, CONNECT SHIELD GROUNDS TO THE CONNECTOR BACKSHELL – THE SHIELD LEADS MUST BE LESS THAN 3.0".
CONNECT OTHER SHIELD GROUNDS TO AIRCRAFT CHASSIS WITH AS SHORT A CONDUCTOR AS PRACTICAL.
ONLY ONE TRAFFIC SOURCE MAY BE CONNECTED TO THE GMX 200. IN ADDITION TO THE TRAFFIC SOURCES CONTAINED IN THIS FIGURE,
THE GDL 90 IS ALSO CONSIDERED A TRAFFIC SOURCE.
THESE OPTIONAL DISCRETE CONNECTIONS ARE NOT REQUIRED IF THE GMX 200 IS CONFIGURED FOR 'TAS+DISP'. IN THIS CASE, THE GMX 200
WILL NOT CONTROL THE TRAFFIC ADVISORY SYSTEM OPERATION.
GMX 200 MUST BE CONFIGURED FOR TRAFFIC SOURCE: TAS OR TAS+DISP (SEE NOTE 4), AND TRAFFIC FUNCTION MUST BE ENABLED. SKYWATCH
MUST BE CONFIGURED FOR AN ARINC 735 TYPE 1 DISPLAY. THE SKYWATCH SOFTKEY (DISCRETE) INPUTS MAY BE DRIVEN BY MULTIPLE DISPLAY SOURCES.
GMX 200 MUST BE CONFIGURED FOR TRAFFIC SOURCE: TAS OR TAS+DISP (SEE NOTE 4), AND TRAFFIC FUNCTION MUST BE ENABLED. KMH 880 KMH 820) AND
KTA 870 (KTA 810) SYSTEMS MUST HAVE TRAFFIC CONFIGURED FOR 'CONTROLLER TYPE: DISCRETE' AND 'DISPLAY VALID: IGNORE'. THE KTA 810/KMH 820
INPUTS CANNOT BE DRIVEN BY MULTIPLE DISPLAY SOURCES.
TRAFFIC FUNCTION IS ONLY AVAILABLE WITH THE GMX 200 I/O MODEL. RS-232 PORTS 1, 2, 4 OR 5 MAY BE USED INSTEAD OF PORT 3. GMX 200 MUST BE
CONFIGURED FOR RYAN TCAD SOURCE: PORT 3 (OR APPROPRIATE PORT) AND TRAFFIC FUNCTION MUST BE ENABLED.
TCAD 9900B VERSION 1.08 (OR LATER) OR 9900BX VERSION 1.11 (OR LATER) IS REQUIRED FOR PROPER OPERATION WITH GMX 200.
GMX 200 MUST BE CONFIGURED FOR TRANSPONDER TIS SOURCE: GTX 330 AND THE TRAFFIC FUNCTION MUST BE ENABLED. THE GTX 33/330 ARINC 429
OUTPUT MUST BE SET TO 'GARMIN W/TIS'. THE 'TIS CONNECT SELECT' DISCRETE INPUT MAY BE DRIVEN BY MULTIPLE DISPLAY SOURCES.
L3 COMM 5
TRC 497 TRC 899
P1 P1
34 42
33 43
S
82 21
(OPTIONAL)
4
85 19
CONNECTIONS TO TIS-A SOURCE
TCAD
8
GMX 200 I/O MFD
RS-232 RX
A
ARINC 429 IN
RS-232 TX
B
GROUND
DISCRETE OUT 2

Figure E-7. Traffic

TRAFFIC ADVISORY
6
HONEYWELL SYSTEM
KTA 810 KMH 820
J10 J10
54 54
A
ARINC 429 OUT
55 55 B
23 23 STANDBY/OPERATE
2 2 FUNCTIONAL TEST
TRAFFIC ADVISORY
GARMIN
GTX 33
GTX 330
P3301
P2002
59 30 A
ARINC 429 OUT 2
58 28 B
S
6 46
TIS CONNECT SELECT
SYSTEM
9
Page E-9
Revision F