How to Enable Access to the
Setup Program
1
Observe the precautions in "Before You
Begin" (see page 41).
Turn off all peripheral devices connected to
the computer. Turn off the computer.
Remove the computer cover.
On iumper block J9Cl-D, move the jumper
pins 4-5 to pins 5-6 as shown below.
from
4 5 6 4 5 6' 4 5 6' '4 5 6'
1 2 3
1 2 3
Replace the cover and turn on the computer.
1 2 3
1 2 3
OM05680
How to Clear CMOS RAM
Normally, you should only have to do this
procedure after you upgrade the BIOS.
1. Observe the precautions in "Before You
Begin" (see page 41).
2. Turn off all peripheral devices connected to
the computer. Turn off the computer.
3. Remove the computer cover.
4. On jumper block JSCl-C, move the jumper
from pins 5-6 to pins 4-5 as shown below.
A
B
4 5 6
4 5 6
1 2 3
1 2 3
5. Turn
on the computer and allow it to boot.
6. Turn
off the computer.
C
D
4 5 6
4 5 6
1 2 3
1 2 3
0M05682