Plug And Play Configuration; Subscreen - Intel PD440FX Product Manual

Using the BIOS Setup Program
Sets the command issued to your
computer enters power-managed mode. The
options are:
Disabled (the monitor is not under power
l
management)
Standby (minimal power reduction)
l
Suspend (significant power reduction)
l
Sleep (default) (maximum power reduction)
l
Inactivity Timer
Sets how long (in minutes) the computer must
be inactive before it enters power-managed
mode. The range is O-255 minutes. The default
10
is minutes.
Hot Key
Sets the hot key for power-managed mode.
Press the hot key while holding down the cCtrl>
and cAlt> keys to enter power-managed mode.
All alphabetic keys are valid entries for this field.
Auto Start On AC Loss
Specifies whether the power supply should
resume after AC power interruption. The options
are:
Disabled
l
Enabled (default)
l

Plug and Play Configuration

Subscreen

This section describes the options in the Plug
and Play Configuration subscreen.
Configuration Mode
Sets how the BIOS gets
Plug and Play ISA add-ir
are:
Use PnP OS (default)
l
Use BIOS Setup
l
If Use BIOS Setup is selected, specify the IRQ
for each non-Plug and Play ISA add-in card you
install on the motherboard (see page 34,
10, 11, 14, 15).
IRQ 3, 4, 5, 7, 9,
tion about non-
cards. The options