Hose & Regulator Installation - Brinkmann Vertex Sear 810-3885-G Owner's Manual

FILLING THE GAS CYLINDER (TANK):
• Allow only qualifi ed licensed gas dealers to properly fi ll or repair your gas cylinder.
• New tanks should be purged prior to fi lling; inform gas dealer if you are using a new tank.
• DO NOT allow the cylinder to be fi lled beyond 80% capacity. Over-fi lled tanks can create a
dangerous condition. Over-fi lled tanks can build-up pressure and cause the valve to expel
propane gas vapors. The vapor is combustible and if it comes in contact with a spark source or
fl ame an explosion causing severe burns, bodily harm, or death could occur.
• Always use a protective cylinder cap when grill is not connected to cylinder.
CONNECTING THE GAS CYLINDER (TANK):
1. Check that the cylinder valve is closed by turning the knob clockwise.
2. Place the cylinder beside the grill on a level surface.
3. Orient the cylinder such that the hose is not kinked or damaged.
HOSE & REGULATOR INSTALLATION:
• DO NOT use any other pressure regulator/hose assembly other than the one supplied with your
grill.
• DO NOT attempt to adjust or repair a regulator.
• Ensure the tank valve is CLOSED prior to connecting the gas cylinder to your grill. Turn the
valve knob clockwise to properly close the valve. Read and follow all instructions and warnings
on the supply hose safety tags. Read and follow all warnings in this manual concerning the safe
use of gas cylinders and the hose and regulator before connecting cylinder to grill. Read and
follow all warnings on the cylinder.
5
WARNING
WARNING