Q Access Keypad Setup Function - Chamberlain LiftMaster Q Installation Manual

Liftmaster q access keypad

Hide thumbs

Table Of Contents

Table of Contents

Enlarged version

Allows the displayed site name to be changed. If

Change the Displayed

Site Name?

YES is selected, setup will proceed to the

Press * for YES

following step. If NO is selected, setup will jump

Press # for NO

to the last parameter.

The first line of the site name displayed on the

Site Name 1st Line:

Your Storage

screen. Use the * and # keys to move left and

right. When the cursor is on a character, it can

1=1QZqz., 0=0-#*$@

be changed by repeatedly pressing the

*=Left #=Right

corresponding number key until the desired

character appears. This is similar to text

messaging in cellular phones. A space is the

last character on every key. Following is a list

of the characters on each key:

1: 1QZqz.,

2: 2ABCabc

3: 3DEFdef

4: 4GHIghi

5: 5JKLjkl

6: 6MNOmno

7: 7PRSprs

8: 8TUVtuv

9: 9WXYwxy

0: 0-#*$@'

The second line of the site name that is

Site Name 2nd Line:

Facility

displayed on the screen. It is changed in the

1=1QZqz., 0=0-#*$@'

same way as the first line.

*=Left #=Right

Message displayed when exiting setup mode.

Setup Complete

Press the # key to return the device to normal

operation. If no key is pressed, the device will

PRESS # WHEN DONE

return to normal operation after a few seconds

and all information will be automatically

saved.

The basic operation of this function depends on having a door equipped

with both a door strike and a door alarm contact. The door strike is

connected to Relay 1 and the door alarm switch is connected to Input 1.

Relay 1 activates the door strike when a valid access command is sent

from the controller. This is the only case in which the hold time for Relay

1 is not determined by the controller. Instead it is set by the "Door Strike

Time" parameter in the Q Access Keypad Setup Function. Once the door

strike is activated, the door can be opened.

To prevent the door from being held or propped open, the "Max Door

Open Time" parameter has been provided in the Q Access Keypad

Setup function. If the door is held open for longer than the time specified

by the "Max Door Open Time", the controller will respond with an alarm

and the "Door Held Open" message. When the door is closed, the

controller will then report "Door Closed".

A request to exit device is typically a push button or motion detector

designed to open a door from the inside. If a request to exit device is

added to Input 2, the door strike will be activated by the controller or by

the signal from the Request to Exit device. If the door is opened without

Relay 1 being active, the controller will respond with an alarm and the

"Door Held Open" alarm message.

If an optional door holder is used, Relay 2 controls that device. When the

door is opened by the controller or by the Request To Exit device, Relay

2 activates to turn on the door holder and hold the door open. To use a

door holder, Relay 2 must be set for "Different Hold Time" in the Setup

Function. The amount of time the door is held is specified by the "Relay

#2 Hold Time" parameter. This time must be set to a value less than the

"Max Door Open Time" to avoid false alarms occurring from the door

being held open too long.