Initial System Setup; Setting The Entry Code Length; Setting The Relay Activation Time; Setting The Maximum Number Of Keypad Errors (Strikes And Out) - Chamberlain Min i-key 500 SN7000255 Programming Manual

Table of Contents

If you decide to change the entry code length after the initial programming, you will need to delete all of the

entry codes before changing the code length. Once you change the entry code length, the old codes will no

longer be valid and cannot be

2. New Entry Code Length (4 or 5)

Example: 8 + 5 + #

Changes entry code length to "5" maximum digits.

This tells the system how long to activate the relay that unlocks/opens your door or gate.

Factory Setting: 10 seconds

for the Main Relay OR

2. Number of Seconds (2-255)

Example: 1 + 15 + #

Sets the main relay's activation time to "15" seconds.

Note: If this relay activates a gate operator with a momentary contact closure, set the relay activation

time for a short period (for example, 2 seconds). A longer activation time might cause the gate to

repeatedly open and close until the activation period has expired.

This feature prohibits unauthorized persons from guessing an entry code. Anyone entering an entry code will

have a set number of times to correctly enter his/her code. Each time the code is entered erroneously, it is a

"strike". After x number of "strikes", the system will disallow keypad entries at the unit for 3 minutes.

Factory Setting: 5

2. Maximum Number of Errors Allowed (0-10; 0 = Disable)

Example: 3 + 3 + #

Changes the maximum number of keypad errors to "3".

Initial System Setup

deleted.

Factory Setting: 4 digits

for the Auxiliary Relay

Page 5 of 8

Doc 6001050, Rev E

Initial System Setup

—

Table of Contents