Removal and Replacement Procedures
Processor
To remove the processor:
1. Power down the server. See "Powering Down the Server" in this chapter.
2. Remove the access panel. See "Access Panel" in this chapter.
3. Locate the processor on the system board.
Figure 2-35: Locating the processor on the system board (center
wall removed for clarity)
2-42
COMPAQ CONFIDENTIAL Codename: DarkStar-T Part Number: 203834-003 Last Saved On: 12/28/01 9:29 AM
CAUTION: Always use a new thermal pad and a new heatsink when replacing processors.
Failure to use new components can cause damage to the processor.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the internal
system components to cool before touching them.
CAUTION: The processor socket must be populated at all times. Failure to replace the
processor results in the system failing to boot and halting during the POST. This error
prevents the system from functioning properly.
Compaq ProLiant 320 Server Maintenance and Service Guide