Compaq ProLiant DL320 Maintenance And Service Manual page 22

To remove a DIMM from the system board:
1. Power down the server. See "Powering Down the Server" in this chapter.
2. Remove the access panel. See "Access Panel" in this chapter.
3. Open the DIMM socket latches on the socket to be serviced
the socket when the latches are released.
4. Pull the module out at the same angle as the DIMM socket on the system board
Figure 2-3: Removing a DIMM from a DIMM socket
Observe the following guidelines when installing additional memory:
•
Memory installed in the ProLiant DL320 server must be PC133-MHz registered
SDRAM, 3.3 V, 72 bits wide, ECC modules.
•
To facilitate successive DIMM installations, install the DIMMs in sequential order,
starting with DIMM socket 1. Refer to the illustration provided in this section.
Compaq ProLiant 320 Server Maintenance and Service Guide
COMPAQ CONFIDENTIAL Codename: DarkStar-T Part Number: 203834-003 Last Saved On: 12/28/01 9:29 AM
CAUTION: Electrostatic discharge can damage electronic components. Ensure that you are
properly grounded before beginning any installation procedure. Refer to "Electrostatic
Discharge Information" in this chapter.
CAUTION: Remove DIMMs carefully in order to avoid bumping the controller module on the
system board. The module connector pins can be damaged if the module is moved suddenly.
1
CAUTION: Use only Compaq DIMMs. DIMMs from other sources can adversely affect data
integrity.
1
2
Removal and Replacement Procedures
. The module pops out of


.

2-9