Compaq ProLiant DL320 Maintenance And Service Manual page 23

Removal and Replacement Procedures
To replace a DIMM on the system board:
IMPORTANT: A DIMM can be installed only one way. Be sure to match the key slots on the module
with the tabs on the memory slot. Push the module down into the slot until it is fully inserted and
properly seated.
1. Identify the correct DIMM socket to populate. Refer to the illustration provided in this
section.
2. Open the DIMM socket latches if they are not already opened.
3. Align the key slot in the bottom edge of the DIMM with the tab in the expansion socket.
4. Insert the DIMM at the same angle as the DIMM socket on the system board
DIMM enters the socket, the latches close
Figure 2-4: Installing a DIMM in a DIMM socket
5. Press down firmly on the DIMM while pushing the latches inward until the latches snap
into place.
2-10
COMPAQ CONFIDENTIAL Codename: DarkStar-T Part Number: 203834-003 Last Saved On: 12/28/01 9:29 AM
CAUTION: The system does not recognize improperly aligned or seated DIMMs.
2
CAUTION: Use only Compaq DIMMs. DIMMs from other sources can adversely affect data
integrity.
.

2
2
1
Compaq ProLiant 320 Server Maintenance and Service Guide
. As the