Removal and Replacement Procedures
To remove the access panel:
1. Power down the server. See "Powering Down the Server" in this chapter.
2. Press and hold down the locking latches
.
3. Slide the access panel approximately 1.25 cm (0.5 inch) toward the rear of the unit and
lift the panel to remove it
.
1
1
1
2
Figure 2-1: Removing the access panel
Reverse steps 1 through 3 to replace the access panel. When the locking latches snap into
place, the access panel is secure.
Compaq ProLiant 320 Server Maintenance and Service Guide
2-7
COMPAQ CONFIDENTIAL Codename: DarkStar-T Part Number: 203834-003 Last Saved On: 12/28/01 9:29 AM