Hill Start Assist; Using Hill Start Assist; Switching The System On And Off - Ford TOURNEO CONNECT Owner's Manual

1. Press the foot brake pedal firmly.
2. Pull the parking brake lever up to its
fullest extent.
To release the parking brake:
1. Press the brake pedal firmly.
2. Pull the lever up slightly.
3. Press the release button and push the
lever down.

HILL START ASSIST

WARNINGS
The system does not replace the
parking brake. When you leave your
vehicle, always apply the parking
brake. Failure to leave your vehicle securely
parked may lead to a crash or injury. See
Parking Brake (page 96).
You must remain in your vehicle
when the system turns on. At all
times, you are responsible for
controlling your vehicle, supervising the
system and intervening, if required. Failure
to take care may result in the loss of
control of your vehicle, serious personal
injury or death.
The system will turn off if a
malfunction is apparent or if you rev
the engine excessively. Failure to
take care may result in the loss of control
of your vehicle, serious personal injury or
death.
The system makes it easier to pull away
when your vehicle is on a slope without the
need to use the parking brake.
When the system is active, your vehicle will
remain stationary on the slope for two to
three seconds after you release the brake
pedal. This allows time to move your foot
from the brake to the accelerator pedal.
The brakes are released automatically
Tourneo Connect (C4A) M1 Kombi/N1 Kombi, ET7J-19A321-AKA (CG3606en) enGBR, Edition date: 02/2014
Brakes
once the engine has developed sufficient
drive to prevent your vehicle from rolling
down the slope. This is an advantage when
pulling away on a slope, for example from
a car park ramp, traffic lights or when
reversing uphill into a parking space.

Using Hill Start Assist

1. Press the brake pedal to bring your
vehicle to a complete standstill. Keep
the brake pedal pressed.
2. If the sensors detect that your vehicle
is on a slope, the system will activate
automatically.
3. When you remove your foot from the
brake pedal, your vehicle will remain
on the slope without rolling away for
about two to three seconds. This hold
time will automatically be extended if
you are in the process of driving off.
4. Drive off in the normal manner. The
brakes will be released automatically.

Switching the System On and Off

Your vehicle comes with this feature
already enabled. If required, you can switch
this feature off using the information
display. See General Information (page
58).
The system will remain on or off depending
on how it was last set.
97