Ford TOURNEO CONNECT Owner's Manual page 155

WARNINGS
Screwing the bottle onto the bottle
holder will pierce the seal of the
bottle. Do not unscrew the bottle
from the holder as the sealant will escape,
which could cause serious personal injury.
A Label
B Sealant bottle
C Sealant bottle hose
D Bottle holder
E Pressure gauge
F Power plug with cable
G Compressor switch
Tourneo Connect (C4A) M1 Kombi/N1 Kombi, ET7J-19A321-AKA (CG3606en) enGBR, Edition date: 02/2014
Wheels and Tires
1.
2. Peel off the label A showing the
3. Take the hose H with the pressure relief
4. Connect the hose H with the pressure
5. Engage the sealant bottle B into the
6. Remove the valve cap from the
7.
8. Make sure that the compressor switch
9. Insert the power plug F into the cigar
10.
11.
12.
Note: If a tire pressure of 26 psi (1.8 bar) is
not reached do not continue.
153
H Repair kit hose
I Pressure relief valve
Remove the kit from the wrapping.
maximum permissible speed of 50
mph (80 km/h) from the sealant bottle
and attach it to the instrument panel
in the driver's field of view. Make sure
the label does not obscure anything
important.
valve I and the power plug with cable
F out of the kit.
relief valve I to the sealant bottle B.
bottle holder D.
damaged tire.
Screw the sealant bottle hose C firmly
onto the valve of the damaged tire.
G is in position 0.
lighter socket or auxiliary power socket.
See Auxiliary Power Points (page
80). See Cigar Lighter (page 80).
Start the engine.
Move the compressor switch G to
position 1.
Inflate the tire for no longer than 10
minutes to an inflation pressure of
minimum 26 psi (1.8 bar) and a
maximum of 51 psi (3.5 bar). Move
the compressor switch G to position
0 and check the current tire pressure
with pressure gauge E.