Jump Starting The Vehicle - Ford TOURNEO CONNECT Owner's Manual

JUMP STARTING THE VEHICLE

WARNINGS
Do not use fuel lines, engine rocker
covers or the intake manifold as
grounding points.
Connect batteries with only the same
nominal voltage.
Always use booster cables with
insulated clamps and adequate size
cable.
Note: Do not disconnect the battery.
To Connect the Booster Cables
A Flat battery vehicle
B Booster battery vehicle
1 Positive connection cable
2 Negative connection cable
Tourneo Connect (C4A) M1 Kombi/N1 Kombi, ET7J-19A321-AKA (CG3606en) enGBR, Edition date: 02/2014
Roadside Emergencies
120
1. Position the vehicles so that they do
not touch one another.
2. Switch the ignition off and any
electrical equipment.
3. Lift up the battery positive connection
point cover. For item location, refer to
the appropriate under hood overview.
See Maintenance (page 131).
4. Connect the positive (+) terminal of
vehicle B with the positive (+) terminal
of vehicle A (cable 1).
5. Connect the negative (-) terminal of
vehicle B to the Jump start stud of
vehicle A (cable 2).
WARNINGS
Do not connect directly to the
negative (–) terminal of the flat
battery.