Setting The Color Temperature; Setting The Sdi Out Output Lut; Selecting The Fan Operating Mode - Sony F65 Operation Manual

3-3-7 Setting the Color Temperature

The color temperature can be set to 3200K (tungsten),
4300K (tungsten), or 5500K (daylight) to match the
shooting environment.
1
Select the color temperature on settings page 1, then
press the MENU SEL/ENTER dial.
Settings page 1
Color temperature
2
Turn the MENU SEL/ENTER dial to select the color
temperature, then press the MENU SEL/ENTER dial.
To set using the VF menu
Set the Color Temperature on the <Base Setting> page in
the Camera menu (page 43).
3-3-8 Setting the SDI OUT Output
LUT
The image output from the SDI OUT connectors is
configured using a Look-up table (LUT). The images shot
with the camera are intended for processing in post-
production, and are not suitable for checking the results of
shooting as-is on the scene. Setting a LUT changes the
tone of the image displayed on a monitor connected to an
SDI OUT connector, without affecting the main RAW
image output, for ease of monitoring.
Setting Description
Off No LUT is configured.
709(800%) (default) Outputs a signal that extends the
dynamic range by up to 800% in
video terms based on ITU-R709 with
conventional monitor gamma.
S-Log2 Outputs a non-adjustable signal that
uses S-Log gamma. Up to 1300%
input light level can be reproduced.
30
Basic Settings using the Subdisplay
Setting Description
HG8009G40 Outputs a signal using hypergamma
with 800% dynamic range, 109%
white limit, and 40% video output for
18% gray card reflection.
HG8009G33 Outputs a signal using hypergamma
with 800% dynamic range, 109%
white limit, and 33% video output for
18% gray card reflection.
[User1] to [User5] You can select an imported LUT, from
up to five created using CVP File
Editor, belonging to the group
selected on the <LUT FILE> page in
the VF menu.
1
Select the monitor look-up table on settings page 1,
then press the MENU SEL/ENTER dial.
Settings page 1
2
Turn the MENU SEL/ENTER dial to select the look-
up table to apply, then press the MENU SEL/ENTER
dial.
To set using the VF menu
Set on the <LUT> page in the VF/SDI menu (page 46).
3-3-9 Selecting the Fan Operating
Mode
You can set the operating mode of the camera's built-in
fans. The mode can be set to silence the fan speed noise or
to provided maximum cooling to suit the shooting
environment. You can select one of the following operating
modes.
LUT