Setting The Voltage Warning Values; Magnifying The Viewfinder Display - Sony F65 Operation Manual

Item Setting
[Status/Menu] VF Sets whether to display status
information in the VF connector
signal.
SDI Sets whether to display status
information in the SDI OUT
connector signal.
[Marker] VF Sets whether to display markers in
the VF connector signal.
SDI Sets whether to display markers in
the SDI OUT connector signal.
Color Sets the display color of markers.
Brightness Sets the marker display brightness in
the range 1 to 10 (maximum
brightness is 10).
Specifying the markers to display
When the marker display is turned On on the <Mix> page,
you select the markers for display on the <Marker> page in
the Display Info menu.
<Marker> page
The default setting for all markers is "Off."
Item Setting
Center Marker Sets whether to display the center
marker.
Effective Sets whether to display the effective
pixel area.
Aspect Ratio Selects the aspect ratio when Effective
is set to On. The following options are
available.
2.39:1, 2.35:1, 1.90:1, 1.85:1, 1.78:1,
1.66:1, 1.33:1, Variable*
* When Variable is selected, the displayed
Width Specifies the width of the effective pixel
area (960 to 1920 pixels) when Aspect
Ratio is set to Variable.
Height Specifies the height of the effective pixel
area (540 to 1080 pixels) when Aspect
Ratio is set to Variable.
38
Viewing and Setting the Viewfinder Display
aspect ratio is determined by the Width and
Height settings.
Example: Variable (1.78:1).
3-7-3 Setting the Voltage Warning
Values
The Near End and End values used to issue battery voltage
warnings when the supply voltage drops are set on the
<Battery Alarm> page in the Config menu.
Two Near End and End values can be saved, and you can
switch between them as required.
<Battery Alarm> page
Item Setting
DC IN (24V) Type Selects the 24 V system supply settings.
You can set Near End and End
threshold values for both Type1 and
Type2.
Near End Sets the 24 V power supply Near End
value (20.5 V to 30.0 V). The default is
22.2 V.
End Sets the 24 V power supply End value
(20.0 V to 24.0 V). The default is 21.6 V.
DC IN (12V) Type Selects the 12 V system supply settings.
You can set Near End and End
threshold values for both Type1 and
Type2.
Near End Sets the 12 V power supply Near End
value (11.0 V to 17.0 V). The default is
11.1 V.
End Sets the 12 V power supply End value
(10.5 V to 14.0 V). The default is 10.8 V.
3-7-4 Magnifying the Viewfinder
Display
The image displayed in the viewfinder can be magnified by
assigning the Mag function to an ASSIGN button. The
magnification changes between 2-times, 4-times, and Off
each time the ASSIGN button is pressed.
The position of the magnified image displayed in the
viewfinder can be adjusted by assigning the Mag Position
function to another ASSIGN button. The position of the
magnified image moves one step from top left to bottom
right each time the ASSIGN button is pressed.