Setting The Shutter Value - Sony F65 Operation Manual

F65RAW-HFR mode:
23.98pForPB, 29.97pForPB, 24pForPB, 25pForPB,
S119.88p (23.98p), S119.88p (29.97p), S120p (24p),
S120p (25p)
The mode can be switched between F65RAW mode, HD
mode, and F65RAW-HFR mode on the <System Format>
page in the VF menu.
For details, see "3-5 Setting the Shooting Mode" (page
35).
Note
It is recommended that the power be turned off and back
on again after changing the video format.
Changing the video format
1
Select the video format on settings page 1, then press
the MENU SEL/ENTER dial.
Settings page 1
Video format
2
Turn the MENU SEL/ENTER dial to select the video
format, and press the MENU SEL/ENTER dial.
To set using the VF menu
Set on the <System Format> page in the Camera menu
(page 43).
VF and SDI OUT connectors output format
Setting the camera main video format automatically
determines the signal format that is output on the VF and
SDI OUT connectors.
Camera image VF connector
output
23.98p 23.98PsF
29.97p 29.97PsF
24p 24PsF
25p 25PsF
50p 50i*
Camera image
59.94p
S59.94p
S60p
* The output image scan type can be set to Interlace or Frame Drop.

3-3-3 Setting the Shutter Value

The shutter of the camera can be viewed and adjusted, with
settings displayed as shutter angles, just as for a film
camera. Two operation methods are available for the
adjustment: stepwise and continuous.
Step mode
Frequently-used shutter angle values can be selected,
enabling step selection of the shutter values.
Step No.
1
2
3
4
5
6
7
8
9
10
a) Selectable for the electronic shutter only.
The corresponding shutter speeds vary according to the
frame frequency and frame rate of the selected video
format.
Continuous mode (ECS)
The shutter value can be changed smoothly in continuous
mode in the range 4.2° to 360.0° (electronic shutter) or
11.2° to 180.0° (mechanical rotary shutter).
To obtain your desired shutter value quickly, select a value
nearest your desired one in Step mode, then switch to
Continuous mode and adjust the shutter value.
SDI OUT connector
Changing the shutter value in Step mode
output
In Step mode, one of the registered shutter values can be
23.98PsF
selected.
29.97PsF
24PsF 1
25PsF
50i*
VF connector
output
59.94i*
59.94i*
60i*
Shutter angle
a)
360.0
a)
270.0
180.0
172.8
150.0
144.0
90.0
45.0
22.5
11.2
Select the shutter value on settings page 1, then press
the MENU SEL/ENTER dial.
Basic Settings using the Subdisplay
SDI OUT connector
output
59.94i*
59.94i*
60i*
27