Table of Contents
Advertisement
Caution: The RS-232 serial port on the camera is not a
network connection.
8. Re-attach the bubble by screwing it to the housing.
9. See "Accessing the camera over the internet" on page
18 to configure the camera over the internet. Refer to
the Configuration Manual for detailed information.
TVP-1122/3122 pendant-mount camera
1. Prepare the mounting surface and install the camera
bracket.
2. Attach the safety cable to the bracket and then route the
cables from the pendant bracket as shown below.
3. See "Accessing the camera over the internet" on page
18 to configure the camera over the internet. Refer to
the Configuration Manual for detailed information.
Flush-mount camera
1. Drill a hole on the ceiling using the drill template.
Installation Guide
Safety cable
11
Advertisement
Table of Contents
