Table of Contents
Advertisement
2. Tie three safety cables (not supplied) to the safety
hooks on the camera and hang the camera from a
secure point.
3. Unscrew the bubble from the camera and remove the
protective tape from the PTZ module.
4. Press the two tabs on either side of the PTZ module
and remove it from the camera housing.
5. Route the cables from the bracket and connect them to
the PCB of the module through the cable entry hole on
the top of the housing.
Note: If alarm and audio input/output relays are to be
used, also connect them to the PCB of the module.
6. Adjust the height of the two housing tabs by turning the
screw on which they are attached. The distance (h) of
the tabs from the housing ring must be greater than the
thickness of the ceiling.
12
Installation Guide
Advertisement
Table of Contents
