Table of Contents
Advertisement
Problem Solving
If all indicators are off, check that the power cord is connected correctly and that the power is being supplied normally.
Sometimes, when the power cord is unplugged, the
Status
Cause
Internal Error
Fan Error
Sensor Error
High Temp Error
(overheating)
Lamp Error
Lamp Failure
indicator remains lit for a short period, but this is not an error.
t
Stop using the projector, remove the power plug from the electrical outlet, and contact your local dealer or the nearest address provided in the
Epson Projector Contact List.
Epson Projector Contact List
s
Stop using the projector, remove the power plug from the electrical outlet, and contact your local dealer or the nearest address provided in the
Epson Projector Contact List.
Epson Projector Contact List
s
The lamp turns off automatically and projection stops. Wait for approximately five minutes. After approximately five minutes the projector
switches to standby mode, so check the following two points.
• Check that the air filter and air exhaust vent are not blocked, and that the projector is not positioned against a wall.
• If the air filter is clogged, clean or replace it.
s "Cleaning the Air Filter" p.114, "Replacing the Air Filter"
If the error continues after checking the points above, stop using the projector, remove the power plug from the electrical outlet, and contact
your local dealer or the nearest address provided in the Epson Projector Contact List.
Epson Projector Contact List
s
When using at an altitude of 1500 m or more, set High Altitude Mode to On.
s "Extended Menu"
p.80
Check the following two points.
• Take out the lamp and check whether it is cracked.
s "Replacing the Lamp"
p.116
• Clean the air filter.
s "Cleaning the Air Filter"
p.114
: Lit
: Flashing
: Off
: Varies according to the projector status
Remedy or Status
p.119
97
Advertisement
Table of Contents
